„h Latex gloves- the latex gloves are needed when you are removing the protective cover of the x-ray film that has been contaminated.

„h Paper towels- the paper towel is used to set the x-rays on it to prevent contamina

2. Processing into the developer is the next step. You take the wet mount of films and place it into the developer tank. Slowly sway the wet mount side to side inside the solution to remove air bubbles that might attach itself to the films and could cause distortion. Hook wet mount to the tank and place cover back on the dip tank. Set the timer to the appropriate amount of time. Usually, about 5-7 minutes is needed depending on solution manufacturer guidelines. Once the timer has gone off remove tank cover and wet mount and place into the center section in the tank, which hold the water. Allow the wet mount to remain in the water section for one minute to completely remove the developer solution.

-- The film was not left in fixer long enough

-- The film is left inside the fixer too long

„h Fixer solution- the fixer is a solution that is used after the developer; this chemical allows the image on the radiograph to become permanent on the film.

Some topics in this essay:
Introduction Dental, Drying Instructions, Note Touching, NOTE Failing, NOTE Water, wet mount, dental x-rays, fixer solution, developing dental x-rays, safe light, developer solution, developing dental, set timer, developing x-rays, x-rays „h, developing process, remove wet mount, 65 70 degrees, film water tank, x-rays using manual,