In phase I, the design, system requirements are determined based on the applications and the required speed of the network. Once the system requirements are established, the network equipment is selected along with the computer workstations. In phase II, the equipment is installed and connected through the network. The home network can be connected through category 5 wire, existing phone lines, and or wireless transmitters and receivers. A firewall is connected between the home office and the outside world. The firewall will protect your network from hackers trying to access y

Now that the computers are ready, wiring from each station to a central location must be installed (two cables per location are recommended). The central location should be near a cable connection; this is because the network will connect to the Internet using a cable modem. Once the cables are installed, the wires must be attached to a cat5 connector on the computers side, and to a patch panel at the central location. A punch down tool is used to attach the wires on to each connection. Connection testers can be used to confirm that the wires are properly connected (punch down tool, cat5 connector, cable testers shown in illustration).

Flexibility- An employee with a home-connected network has an opportunity to adjust a work schedule to accommodate for traffic conditions in commute areas; a productive morning in the home office will allow traffic to clear for a smooth commute later in the day.

For the example installation, the computer system will be configured to support word-processing applications and some graphic 2D & 3D applications. The computers will be configured with the following (sample system in illustration):

Access- Connections between a home computer and a computer in a main office will allow an employee to transfer documents from one location to another. Printers and other hardware peripherals can also be shared between systems.

The first step when setting up a home computer network is to verify that all computer systems are functioning properly running a Windows 2000 or a Windows 98 operating system (OS). Configure all systems with the same OS to decrease the chance of incompatibility between OS and application software. Once the systems are working properly, power down and open the case on each system. Install the network card (NIC) into each machine. Replace case computer case then place computers in final locations within your home. To simplify wiring, locate computers near existing phone jacks and power outlets. Start up computer and be sure the proper network drivers are installed on each machine.

Some topics in this essay:
OS Configure, Information System, Conclusion Home, Office DiMarzio, AT&T Linksys, Internet E-mail, Near Me”, ISP AT&T, Access- Connections, Set IP, home office, home network, ip address, cable modem, category 5, computer network, cat5 pre-built cable, network card, · computer, computer systems, punch tool, set ip address, cable modem connected, “my network places”, ip address computer,