(855) 4-ESSAYS

Type a new keyword(s) and press Enter to search

Does the resistance change with the length of the wire?

            
             Variables Why controlled? How controlled?.
             Length of wire The resistance changes with the length of wire. There are different amount of electrons in different length if wires. This will affect the accuracy of results if the wires are not measured properly. This is an independent variable. I will use a metre stick to measure the wire at eye level for accuracy.
             The wire must be pulled tight and held into place while measuring to ensure the length is accurately measured.
             Current We need to keep the current the same throughout the experiment because we are not measuring the current. We are investigating the resistance. This is a controlled variable. We will use a variable resistor to keep the current at a constant measure. We are going to keep the current at 0.3 amps.
             Resistance This is a dependant variable because this is what I want to find out about. This is not controlled. We are going to measure the resistance by using a voltmeter and ammeter. We work out the resistance by the formula: .
             Resistance (ohms, Ù) = Voltage (volts, V).
             Amps (A).
             I will calculate this by using a calculator so I avoid any possible errors.
             .
             Fair Test.
             The only variable that I will be altering will be the length of the wire as this is the main variable. The other variables, I will keep controlled to make it a fair test. I will keep my controlled variables the same by making sure that I have implied the same strategy for each experiment. The length of the wire is going to be controlled by using a metre stick, and the current is going to be controlled by using a variable resistor - this can change the current to any number, but we are going to keep the current at a constant measure (0.3 amps) to make it a fair test. I will also do all calculations using a calculator (averages, finding the resistance). Each experiment should be repeated 3 times to make sure the results are reliable and accurate.


Essays Related to Does the resistance change with the length of the wire?

1. Resistance

... the the value of resistance of a resistance wire would increase with the increase of the length of the wire. By looking at my graph, one will see that as the length of the resistance wire increase, so does the value of resistance. The curve of the graph shows a sharp steep increase, followed by a steady increasing slope. This proves the first part of my hypothesis to be correct, and I am able to conclude that as the length of the resistance wire increases, so does the value of resistance. From my current knowledge and research of resistance, I am confident in saying that the reason for t...

  • Word Count: 1285
  • Approx Pages: 5
  • Grade Level: High School

2. The Science of Electrolysis

... and the anode is the provider of this layer. The atoms which are plated are transferred from the electrolyte solution, therefore, to attain a particular coat the electrolyte must be the salt product of the cathode (Anon., 2016). The potential difference is controlled in the plating process; a low amount of constant voltage is preferable as it provides enough efficiency of metal deposition however, does not distribute enough energy to cause a large sub-reaction with the water molecules of the ... with electrons from the cathode and donate electrons to the anode. This would therefore incr...

  • Word Count: 4896
  • Approx Pages: 20
  • Has Bibliography
  • Grade Level: High School

3. Pastured Poultry

... the pasture. Beck-Chenoweth uses a shelter on skids enclosed with chicken wire with litter- covered floors, tarp-covered gable roofs, and doors on both ends. The only ... the intensification of environments in which poultry are maintained. Such intensification is a function of escalation of land, energy, and labor costs. Whether the rate of change of these nongenetic factors is faster than biological change is an important issue in the consideration of ... The primary damage is reduced efficiency of feed utilization, but death has been observed in severe infections. Chickens of three to ...

  • Word Count: 5020
  • Approx Pages: 20
  • Grade Level: High School

4. Coils, Springs and Shock Absorbers

... with resemblance of the diagram above. This spring is circular in cross section. The diameter of the spring is fixed according to the stiffness needed before the manufacturing process. Dimension of the spring. Material: Alloy spring steel Modulus of rigidity, G = 4100 Mean diameter of a coil, D= 62mm Diameter of wire, d = 8mm Outer diameter of spring coil, D0 = D +d = 70mm Total no of coils, n1= 18 Height, h = 220mm No of active turns n= 14 The dimension of ... ethics identify a specific precedence with respect to the engineer's consideration for the public, clients, employers, and the p...

  • Word Count: 3957
  • Approx Pages: 16
  • Grade Level: High School

5. Research And Development

... will work. While invention is a process, the result of the process, unfortunately, is also called invention. The first prototype (basic working model) of the telephone, the automobile, the television set, the microchip - each of these is an invention. Invention is usually based on scientific knowledge and is the product of the individuals, either working on their own or as members of corporate R & D staffs. INNOVATION Innovation, a second element of technological change, draws directly on invention. While invention ... even better superconducting materials. In 1987, a team headed by phy...

  • Word Count: 5057
  • Approx Pages: 20
  • Has Bibliography
  • Grade Level: Undergraduate

Got a writing question? Ask our professional writer!
Submit My Question